|
Anybody use a WhamBam flexi plate? I was able to scavenge one from another goon's printer for my Mono X and got it to print last night. Need to fiddle a bit with some details, but my main question is about cleaning it. Is resin going to damage the magnet or dissolve the glue or anything? Do I need to be washing the build plate off as well now? For my solid build plate I just scraped the prints off then put it right back on the printing arm and left it for the next print. Does that cause problems now?
|
# ? Apr 30, 2024 18:04 |
|
|
# ? May 2, 2024 12:01 |
|
I didn't have a whambam one but the magnet glue holding the cheap flexplate I got did eventually weaken and come off the build plate. Only noticeable when I was pulling the plate off, didn't mess up any prints. This was also a cheap AliExpress one and after about 18 months of use so I'd say I got my money's worth.
|
# ? Apr 30, 2024 19:44 |
|
It looks my my incredibly old Anycubic Mega Zero is completely dead now. What's a cheap FDM printer that isn't complete garbage? I don't care about printing in multiple colors, but some QOL upgrades compared to my old one would be nice.
|
# ? May 2, 2024 12:00 |