|
Wow. What the hell happened to your axle?
|
![]() |
|
![]()
|
# ? May 18, 2024 18:47 |
|
Lord Yod posted:Wow. What the hell happened to your axle? A rubber boot holds them in, he broke something to rip the wheel out of the wheelwell, and the boot just rips and the tripod joint falls apart.
|
![]() |
|
Billy Zane posted:
That's the dealership I work at. I didn't see the guy pulling the car in, but from what I could tell looking at it was that he hit the curb dead on at high speed, and broke the control arm and studs off, car got fixed and put back into service a week or so later.
|
![]() |
|
This is the best https://www.youtube.com/watch?v=RuUya0fimmQ
|
![]() |
|
blambert posted:This is the best ![]() WTF did he tie that strap to that it pulled the whole rear end of the car off?
|
![]() |
|
I'll tell you what it wasn't. The tow hook.
|
![]() |
|
blambert posted:This is the best This... this is a thing of beauty. Thank you for this.
|
![]() |
|
Exploded the rear diff on the Defender at the rally this year. A spider gear decided to make a hasty exit out the back of the housing. What I get for trying to show off in front of photographers from 3 different magazines. I was so hoping for a cover shot finally. Who did get on that cover? My wife in our Classic. *sigh*![]()
|
![]() |
|
ZombieLicker posted:I'll tell you what it wasn't. The tow hook.
|
![]() |
|
blambert posted:This is the best Christ, people. You shovel the snow out from under and around the car first! I can't imagine the feeling the driver of the truck and/or car owner and/or whoever tied it down must have had when the back of the car just exploded like that.
|
![]() |
|
orange lime posted:Christ, people. You shovel the snow out from under and around the car first! Truck Driver: Hahaha, my truck is tough! Car Owner: My mom is going to kill me! Camera Man: I'm glad I got that on Camera! Me: They should have used the truck to push the car back into the drive way so he could back out through the gap visible.
|
![]() |
|
blambert posted:This is the best He's lucky that bumper didn't just break at the hook. Ive seen those tow straps slingshot back into someone.
|
![]() |
|
autophreak posted:He's lucky that bumper didn't just break at the hook. Ive seen those tow straps slingshot back into someone. I'd say they're all lucky to live through each day with that level of intelligence.
|
![]() |
|
autophreak posted:He's lucky that bumper didn't just break at the hook. Ive seen those tow straps slingshot back into someone. They shouldn't have even been using tow straps in the first place. That's a job for a loving recovery strap. You need to not have any goddamn metal chunks at the end and for the strap to have some elasticity.
|
![]() |
|
![]() Click here for the full 1024x766 image. Someone sent me this picture, Its a piston/cylinder wall. How does this happen?
|
![]() |
|
hippynerd posted:How does this happen? No torque plate was used while finishing the cylinder, so the cylinder was not put under proper stresses, and cause minute undulations in the cylinder wall. This is my understanding, someone correct me if I am wrong.
|
![]() |
|
I've done that to 2-strokes by overheating them so much the piston swells and touches the cylinder wall. I've done some really horrible things to 2-strokes. ![]()
|
![]() |
|
DefaultPeanut posted:No torque plate was used while finishing the cylinder, so the cylinder was not put under proper stresses, and cause minute undulations in the cylinder wall. When that happens, the undulations are usually more gradual in appearence and in a pattern that tends to correspond to the head bolts - my money's on insufficent cylinder clearance and/or overheating. Like the previous poster said, the piston just grows until it breaks through the oil film and galls against the cylinder wall.
|
![]() |
|
I should have said more when I posted. I have also seen that predominantly in 2-stroke engines, as a result of the lack of a torque plate when boring / honing. As there was no plate, the material was able to "slouch" and bulge slightly, mainly around the head bolts. Like was said, when it overheats, that is the first thing (the bulged spots) to contact the piston when the film of oil is broken.
|
![]() |
|
Rogz posted:I've done that to 2-strokes by overheating them so much the piston swells and touches the cylinder wall. Heh, I know what 12,000 rpm sound like on a old 250cc. I also know what a siezed lower end sounds like as well. Those hot mags you'd replace your stock system with were pretty loving awesome.
|
![]() |
|
teh jhey posted:http://www.youtube.com/watch?v=et-g4P8SbJQ ![]()
|
![]() |
|
The #1 piston from an old civic I owned with an H23A1 engine in it. I had been running a crappy Zex fogger nitrous kit on it through the intake with no additional fuel for about 3 months when this happened. This is the only picture I still have, it's like the piston is smiling.
|
![]() |
|
4/20 NEVER FORGET posted:![]()
|
![]() |
|
https://www.youtube.com/watch?v=2frjSvo9BBc Bird strike. The mighty 757 maintains V2 and climbs out on one engine. These guys don't even lower the nose a smidge.
|
![]() |
|
Amazing. Really interesting to see how difficult it appeared to bring the thing to a stop when only one engine is available for reverse thrust. It looks like they had the thing cranked to the left when they touched down.
|
![]() |
|
"Bird debris" on the runway. ![]()
|
![]() |
|
Rogz posted:I've done that to 2-strokes by overheating them so much the piston swells and touches the cylinder wall. are you the dick who owned my KTM before me? you dick. (see page 1)
|
![]() |
|
![]() Click here for the full 1024x683 image. wiring harness to the MAF sensor melted, so the ecu assumed airflow had been cut off, and therefore didn't need to inject any fuel.
|
![]() |
|
bisticles posted:Amazing. Really interesting to see how difficult it appeared to bring the thing to a stop when only one engine is available for reverse thrust. It looks like they had the thing cranked to the left when they touched down. You can google RTO procedures where they get the plane at max weight to takeoff speed and then use ONLY the brakes to stop. That is "difficult" to stop (the brakes will catch fire, tires explode, etc - but the plane has to be able to sit/taxi for 5 minutes without having a major fire), this plane could have stopped faster - but the pilot knew once they were on the ground there was no real danger - just wanted to stop the plane nice and easy - knowing it would be best to taxi clear of the runway as well.
|
![]() |
|
Related video off one of the engine failure vids. http://www.youtube.com/watch?v=yNDFkK8zp0c&feature=related
|
![]() |
|
Kadler posted:Related video off one of the engine failure vids. That was NOT what I was expecting. ![]()
|
![]() |
|
Kadler posted:Related video off one of the engine failure vids. Hahhaha everything about that video is retarded.
|
![]() |
|
Disciple of Pain posted:You can google RTO procedures where they get the plane at max weight to takeoff speed and then use ONLY the brakes to stop. That is "difficult" to stop (the brakes will catch fire, tires explode, etc - but the plane has to be able to sit/taxi for 5 minutes without having a major fire) Actually, the brakes shouldn't catch fire, and aircraft tires really don't blow up. When that test is done, the brakes will be glowing white hot, and there may be some grease briefly burning off, but the brakes and wheels aren't actually on fire. Large aircraft tires are normally fitted with fusible plugs that melt at a certain temperature to deflate the tires in a controlled manner, since the tires are inflated to around 200PSI, which makes a blowout insanely dangerous. Here's the video of a 777 doing a rejected takeoff during certification in the 1990's http://www.youtube.com/watch?v=wXpjBxD0Rhg
|
![]() |
|
azflyboy posted:Actually, the brakes shouldn't catch fire, and aircraft tires really don't blow up. I know that the brakes (which are carbon, metal, etc) do not literally catch on fire. But there would very likely have been small fires at the wheels if it was truly a STOP AS FAST AS POSSIBLE kind of thing. It wasn't. It was not a huge deal and there was no reason to try to stop SO fast. And yeah, explode was a hyperbole. As soon as they lose pressure though, they end up shredding to bits (usually still attached though).
|
![]() |
|
Aircraft brakes most certainly can catch on fire.
|
![]() |
|
There's also a video out there of some of the tires exploding when they e: Clarified, and found the video: https://www.youtube.com/watch?v=hRzWp67PIMw Nuevo fucked around with this message at 05:03 on Nov 11, 2009 |
![]() |
|
That's crazy. I think that's a truncated version, does anyone have the full one?
|
![]() |
|
Hahaha that was awesome. They were playing it so cool for a while there then get abandoned by ground control while their plane is on fire. Maybe SOMEONE should have learnt how to use the slide.
|
![]() |
|
Uncontained Turbine Failure:![]() ![]() ![]() LOO fucked around with this message at 06:52 on Nov 11, 2009 |
![]() |
|
![]()
|
# ? May 18, 2024 18:47 |
|
LOO posted:Uncontained Turbine Failure: In this sort of situation, do they even try to fix the damage to the engine, or is it a "trash it and get a new one" kinda thing?
|
![]() |