|
Flash Gordon Ramsay posted:Buttercream. this is actually what's in my arteries
|
# ? May 3, 2021 23:23 |
|
|
# ? May 9, 2024 23:25 |
|
From a few pages back, but if you want a smart rice cooker and don't want to spring for a Zoji, I have been very happy with my Cuckoo.
|
# ? May 5, 2021 13:55 |
|
Started feeling like my stainless steel pan wasn't cooking properly and it had started to wobble so took this jank picture. How did it end up so bad? I've never put it in cold.water and always let it cool down off the heat, until I can basically touch the bottom, before cleaning. The only time cooler liquid has been put it in when it's hot is making a pan sauce, but I've never seen anyone saying making a pan sauce fucks your pan up. I'm pretty sure it wasn't this bad when I bought it. It was this one: https://www.amazon.co.uk/gp/aw/d/B01D34KN56?psc=1&ref=ppx_pop_mob_b_asin_title Not exactly premium but I only bought it in September 2020. Anyone tried to reshape a pan by heating it and hitting it with a rubber mallet like some guides suggest? Or just cut my losses and get a new one? Edit: oh, there's a bunch of recent reviews saying it doesn't fit flat on their hob even after heating it once. Maybe I got scammed. uhhhhahhhhohahhh fucked around with this message at 14:45 on May 5, 2021 |
# ? May 5, 2021 14:32 |
|
some pans will warp permanently if the construction isn't great, unfortunately, and there's no real way to tell what'll happen just by looking
|
# ? May 5, 2021 14:54 |
|
Give it a 1 star review and you are likely to get a free pan as a bribe to take down your review. Then you can leave the 1 star review up because gently caress those guys
|
# ? May 5, 2021 15:27 |
|
uhhhhahhhhohahhh posted:Started feeling like my stainless steel pan wasn't cooking properly and it had started to wobble so took this jank picture. How did it end up so bad? I've never put it in cold.water and always let it cool down off the heat, until I can basically touch the bottom, before cleaning. The only time cooler liquid has been put it in when it's hot is making a pan sauce, but I've never seen anyone saying making a pan sauce fucks your pan up. I'm pretty sure it wasn't this bad when I bought it. You’ll never get it flat again. You can get it flat once, but as soon as you use it again it’ll start warping. Quality is really important in clad stainless steel pans, since you have a couple dissimilar metals sandwiched around each other they already want to stretch differently when heated, and without precise construction and material selection then it’s only a matter of time before the cyclic mismatch in expansion and contraction becomes obvious by warping.
|
# ? May 5, 2021 18:26 |
|
also you may have gotten a counterfeit. there's no way to buy from amazon and be guaranteed not a counterfeit
|
# ? May 5, 2021 18:33 |
|
Got an email today about All-Clad's new graphite-core fully clad stainless pan. Anyone know anything about this kind of pan? Marketing gimmick or actually useful?
|
# ? May 5, 2021 19:08 |
|
The Midniter posted:Got an email today about All-Clad's new graphite-core fully clad stainless pan. Anyone know anything about this kind of pan? Marketing gimmick or actually useful? i mean lots about all-clad is a marketing gimmick tbqh. but the idea is sound and i'm pretty interested in seeing some real-world reviews.
|
# ? May 5, 2021 19:56 |
|
Alright, looks like I'm shopping for a pan again - hopefully off Amazon. Buying pans online is the absolute worst because almost everywhere STILL only gives the measurement for the opening and nothing on the base diameter, so you just got to hope for the best I guess
|
# ? May 5, 2021 20:18 |
|
How well does nonstick cookware recycle? I've just replaced a small saucepan, but don't know if stuff with nonstick coating is okay to toss in with my scrap metal recycling, or if it needs to go in the trash. Fwiw it also has a plastic-covered handle and an exterior coating (I think some sort of thick enamel paint, maybe?) that is chipping off which I'm also unsure about.
|
# ? May 6, 2021 01:49 |
|
That depends on your local processors but it's very low risk to recycle. If they can't handle it, nbd because they can easily separate it. Small, flimsy things which can gum up the machines are way worse to "fingers crossed recycle"
|
# ? May 6, 2021 04:05 |
|
I have a bunch of suet left over from a recipe my gf wanted to make. I also recently bought a wok. Would it be a terrible idea to want to use up this suet by seasoning the wok with it?
|
# ? May 6, 2021 09:02 |
|
The Midniter posted:Got an email today about All-Clad's new graphite-core fully clad stainless pan. Anyone know anything about this kind of pan? Marketing gimmick or actually useful? The idea makes sense, and it seems neat, I’d guess you won’t see a huge meaningful improvement over their copper or aluminum core pans.
|
# ? May 6, 2021 14:58 |
|
Chemmy posted:The idea makes sense, and it seems neat, I’d guess you won’t see a huge meaningful improvement over their copper or aluminum core pans. Basically it's just going to spread and even out the heat a little quicker? I doubt if it's going to be amazingly better because most of the mass of the pan is still stainless steel.
|
# ? May 6, 2021 15:33 |
|
I thought I might as well submit a warranty claim for my pan, they're sending me a new one but it annoyed me because they wanted a list of all the utensils I've used on it... also this:quote:In accordance with our Care Instructions we do advise to use moderate to low heat. Excessive heat will spoil the appearance of the pan by causing discolouration to the surface or deformation of the base. What precious stainless steel pan can't tolerate a medium high heat?? It's not even a powerful hob ffs
|
# ? May 8, 2021 11:47 |
|
When they say the pan can't tolerate heat, there is indeed an absolute limit to how much heat the pan can handle before it degrades, but the real problem is simply heating too rapidly, resulting in a temperature gradient. As long as the pan is all the same heat, it can withstand extreme temperatures without warping. What you need is to gradually heat it up and have a good, evenly diffused burner. Preheating the pan in the oven is also a good way to achieve this.
xtal fucked around with this message at 18:15 on May 14, 2021 |
# ? May 8, 2021 11:58 |
|
It's an electric burner and takes about 10 minutes to boil a medium amount of water if I leave it on 4 out of 6 on the hob, the setting I use for searing.
|
# ? May 8, 2021 12:33 |
|
Does anyone have recommendations for an outdoor, tabletop wok burner? It was surprisingly difficult to find an outdoor table in the first place, but the one I got is 32" high. I was thinking about getting this GasOne, but some of the reviews stated the propane connector is very suspect, and while it's probably fine, 15k BTUs seems less than something like a kahuna. But the Kahuna seems a bit too tall for the table I got and, from seriouseat's review, is a bit too short for sitting on the ground (or in my case, the deck). Thanks!
|
# ? May 14, 2021 15:48 |
|
Nevermind, almost got there. I ended up going with this outdoor double burner
|
# ? May 14, 2021 17:36 |
|
Not sure if it means they'll be introducing a Mk. 5 soon or something, but Thermapen Mk. 4 are currently on sale at thermoworks.com for $69, all colors. I've never seen them go so cheap so if you've been wanting one but haven't been able to justify the C-note, now's the time to pull the trigger.
|
# ? May 18, 2021 16:28 |
|
The Midniter posted:Not sure if it means they'll be introducing a Mk. 5 soon or something, but Thermapen Mk. 4 are currently on sale at thermoworks.com for $69, all colors. I've never seen them go so cheap so if you've been wanting one but haven't been able to justify the C-note, now's the time to pull the trigger. Seconded. Even if they're about to roll out a new version, I dunno what they could add to it that would make one regret buying the Mk. 4 for cheap.
|
# ? May 19, 2021 02:47 |
|
Arcsech posted:Seconded. Even if they're about to roll out a new version, I dunno what they could add to it that would make one regret buying the Mk. 4 for cheap. there’s rumors the new one is also a vibrator
|
# ? May 19, 2021 03:01 |
|
Is the thermapen magnetic? I like my javelin cause I can just stick it on the fridge when I'm not using it.
|
# ? May 19, 2021 03:09 |
|
fart simpson posted:there’s rumors the new one is also a vibrator
|
# ? May 19, 2021 03:11 |
|
horchata posted:Is the thermapen magnetic? I like my javelin cause I can just stick it on the fridge when I'm not using it. Sadly it's not. Won't surprise me if that's what they'll include on the MK5.
|
# ? May 19, 2021 12:08 |
|
I couldn't justify the price of a ThermoPen last time, so I bought a ThermoPop from them instead. it was like $30 and has a magnet.
|
# ? May 19, 2021 12:52 |
|
Do appliances count as equipment? We need to replace a gas range and have an option to go dual fuel. I've says electric only for oven, but that comes at increased cost. I don't cook, but my wife is increasingly picking it up so I'm trying to convince her to not get gas for the oven. For the experienced chefs, how bad (or difficult for me) is a gas oven compared to electric?
|
# ? May 22, 2021 02:05 |
|
Gas ovens are fine. Mine doesn't go below 275, but that's specific to the model. There are environmental concerns with gas, but gas ovens can be just as good as electric
|
# ? May 22, 2021 03:14 |
|
I have a dual fuel oven (gas stovetop) and I really like it for how low it can go in temp and for the convection roast setting. Also when I had a gas leak and the city turned off and LOTTO'd my gas line, I could still cook in the oven so that was a nice save.
|
# ? May 22, 2021 04:04 |
|
definitely go dual fuel if you can swing it
|
# ? May 22, 2021 04:54 |
|
I’ve heard gas ovens are better for baking as they leave a little more moisture in the hot air. Don’t know if that’s true at all. That said my electric has a 100F proof setting that I don’t think gas could do.
|
# ? May 22, 2021 13:15 |
Murgos posted:I’ve heard gas ovens are better for baking as they leave a little more moisture in the hot air. Likewise they're worse for baking since it's harder to control browning.
|
|
# ? May 22, 2021 13:21 |
|
I’m not a pro baker (my wife has celiac) but everything I read said dual fuel was better for baking. I went single fuel because my range wasn’t available with the options I wanted in dual.
|
# ? May 22, 2021 16:10 |
|
Fwiw a gas oven with the light on gets up to around 80-90*F if you want some help proofing bread.
|
# ? May 22, 2021 19:49 |
|
Air fryers: I have been using a cheap, basic one for several months now. I wanna get a nice one - the food I cook has been cheap, healthy, and really drat good. Are there any brands to avoid? Are all the fancy digital controls and thermometer controls of some air fryers actually worth anything? I often cook protein then veggies one after another. Are the dual pot air fryers any good?
|
# ? May 25, 2021 18:57 |
|
I dropped my Thermapen, and now the "close to turn off" feature doesn't work. Has anyone run into this, or any suggestions to try to fix it? I'm not thrilled about having to buy a new one after an incident that, frankly, I feel like it should be able to handle.
|
# ? May 27, 2021 00:50 |
|
you ate my cat posted:I dropped my Thermapen, and now the "close to turn off" feature doesn't work. Contact support, they'll probably agree and replace it.
|
# ? May 27, 2021 01:10 |
|
Best single burner, 120v induction hot plate under $300? Preferred something with some brains (and a probe?) for hotpot and fry oil temperature control. Duxtop seems popular but that could just be good marketing. This is for cooking on the patio. I'm going to do an Ooni 16 for pizza and broiling veggies, induction for everything else. I'm looking forward to smokey sears and messy frying outside!
|
# ? May 30, 2021 17:47 |
|
|
# ? May 9, 2024 23:25 |
|
I like my Duxtop a lot, I use it instead of my electric stovetop
|
# ? May 30, 2021 17:56 |