|
Well, if you had the gear you could tig braze it. Less heat, less crying on cast.
|
#
¿
Mar 22, 2018 03:43
|
|
|
|
| # ¿ May 10, 2024 17:41 |
|
|
Up until about a year ago there was a local radiator shop that would take the end tanks off, boil and poke rods down the tubes, and then replace the tanks. Maybe something similar exists near you??
|
|
#
¿
Apr 24, 2022 16:05
|
|
|
Well, you might not be able to find a place to do it, but you can watch some guy on youtube take a radiator apart. Very satisfying, not very helpful. https://www.youtube.com/watch?v=w36zxJWCgGk
|
|
#
¿
Apr 25, 2022 04:37
|
|
|
For flattening that surface with minimal distortion, I might suggest a bench oil stone, like the kind used for knife sharpening along with some 10W or WD40 as lube. There are a few little wiped looking marks on the first bore, might just take a dowel or steel pin/shaft and some 320/400 or finer grit sandpaper and see if they are high.
|
|
#
¿
Aug 16, 2023 19:32
|
|