- Brekelefuw
- Dec 16, 2003
-
I Like Trumpets
|
I dont know of acraglass would hold up or not. There is some impact albeit not much when the carrier/elevator drops back down to its resting position.
Pretty much I have to put a piece of shim stock here or on the trigger assembly where here hits it to get the elevator to be completely inside the reciever when it's at rest. I'd rather just go the shim route anyway because I could just glue whatever thick ess I need on and file the sides to fit. As opposed to smearing acraglass on then having to fit it.
Long story short will loctite 680 work on flat surfaces?
Why not use a bit of soft solder?
|
#
¿
Jan 23, 2019 22:42
|
|
- Adbot
-
ADBOT LOVES YOU
|
|
#
¿
May 18, 2024 13:57
|
|