- KaiserBen
- Aug 11, 2007
-
|
Blast. I haven't considered that.
Welp, I think I'm still going to try to go directly to registers rather than using device specific libraries, just for the learning experience.
e: Re: robostac
re: SPI: I'm imagining something like: integrating some other IC into the SPI mix which would have, say, five or six high pins, each connected to a separate SPI slave, then in my SPI communication routine I could feed the IC a command depending on which IC I wanted to talk to, and it would bring that particular slave low for communication. I'm just talking out my rear end though.
http://ww1.microchip.com/downloads/en/devicedoc/21952b.pdf
It's a lot more than you need, 16 IO pins, 2 interrupts, etc, but it'd allow you to do what you're looking to do.
|
#
¿
Nov 26, 2012 19:56
|
|
- Adbot
-
ADBOT LOVES YOU
|
|
#
¿
May 7, 2024 08:29
|
|