|
Is there any good resource about hiring a ghostwriter Is there any ballpark rate for ghostwriting? Per page? Per hour? Per draft?
|
# ¿ Jan 19, 2021 20:42 |
|
|
# ¿ Apr 30, 2024 02:50 |
|
The eye is gonna be 2-5 servos run by an amtel chip (cheap) or similar, biggest issue is going to be packaging and testing
|
# ¿ Sep 1, 2022 02:58 |
|
Yes If the mask is more than 1" thick packaging shouldn't be an issue. The Deadpool mask over in the 3d printing thread (15 pages back) is ~2mm thick and would be difficult to package anything under it, in comparison For an eye the size of a softball or smaller you'd probably want something like a towerpro mg90s, and for control board, uh, attiny88 arduino would be a common circuit board to target, even if it's gross overkill for the task. I doubt you would save money doing a custom run of boards when you can utilize a fairly standard system, unless you're doing a run of hundreds+ You should wander over into the cad or 3d printing thread some time if you haven't already
|
# ¿ Sep 1, 2022 18:34 |
|
Shopify for shop Contractor through Upwork My wife setup an Instagram jewelry shop in less than a week with no help full me, looked amazing
|
# ¿ Sep 3, 2022 00:26 |
|
Not sure on the complexity involved but the "self service" STL modification stuff on Prusaslicer has really improved in the last year, worth checking out if you haven't looked at it in a while
|
# ¿ May 17, 2023 02:17 |