|
I was under the impression that you needed footers underneath a two pole lift. Is that not the case? Also, totally jealous you will have a heated and cooled shop. I have a carport if I am lucky and usually a gravel driveway to work in.
|
# ¿ Nov 3, 2013 22:59 |
|
|
# ¿ May 4, 2024 17:47 |
|
For the LED lights I have like that in my garage, I ran a screw in at an angle up against one end of the light. They can't move, no one notices the screw, and no damage to the fixtures.
|
# ¿ Mar 7, 2016 13:12 |
|
https://imgur.com/a/F5kIMD5 After 359,000 miles this one had a bunch of blowby and got a refresh. The transmission is on rebuild #3 at this point. It's got a TransGo shift kit and a Tugger kit as well as a bullet torque converter and I very much recommend these upgrades. I believe there are also some valve body upgrades involving installing pistons backwards and drilling out some of the valve body. It makes for really firm and really fast shifts.
|
# ¿ Jul 8, 2019 02:32 |
|
Absolutely do it yourself. Get some cardboard for when you pull the valve body so you can push the bolts through. It's not that bad.
|
# ¿ Jul 25, 2019 01:44 |