|
genesplicer posted:Thank you! I did a thread years ago about how to carve erasers. It's archived at this point, so I'll need to find it. Basically it boils down to putting an image onto the material then carving away all the stuff that doesn't have your image. I use photocopies, then transfer the image with acetone. The material I use is Speedball speedy carve. When I'm done carving, I mount the stamp on thin plywood and stamp away! Do you print with anything else? I found the speedy carve too floppy and annoying but linoleum is fun.
|
# ¿ Jul 14, 2015 14:04 |
|
|
# ¿ May 13, 2024 11:22 |