I just got the parts for a major system upgrade. Current hardware: Core 2 Q6600 CPU Intel P45 chipset 8 GB RAM BIOS-based AHCI controller New hardware: Core i5-4460 CPU Intel H97 chipset 8 GB RAM UEFI-based AHCI controller I'll be re-using my GeForce GTX 660 Ti card and SSD + harddrives. I want to upgrade to Windows 10 later, but only after getting an extra SSD, current one is near capacity. Question is: What should I do to prepare my existing Windows 7 installation to be moved to the new hardware? How safe is it? I assume I'll have to boot via BIOS emulation, until I can do a clean install of Windows 10. Should I uninstall any drivers beforehand? Preload any drivers into the catalog? Do any registry hacks? nielsm fucked around with this message at 19:07 on Nov 27, 2015 |
|
# ¿ Nov 27, 2015 18:13 |
|
|
# ¿ May 17, 2024 13:33 |
PPills posted:I don't know if this was just a complete coincidence, but one time I moved a hard drive from an old Celeron PC with Windows XP installed, into a new one that had a Pentium D (dual core) 3.4 ghz or whatever. Upon logging in, it detected and proceeded to install, basically almost everything you see in Device Manager: from keyboard and mouse, to graphics adapter, LAN adapter, to even the USB host controllers, among other odd things that you wouldn't typically see being installed, during a plug and play installation. It then proceeded to lock up the computer, and that was the last time it would POST. Motherboard LED would light up, cpu fan would spin, but nothing else; no hard drive noise, nothing on screen, etc. As a counter, I think I did manage to move an XP install, once upon a time, but that's something like 10 years ago.
|
|
# ¿ Nov 27, 2015 21:50 |
Geemer posted:Also, isn't this literally what sysprep is for? It seems to be, and it's what everything else I've (since) found also recommends, so going to do that. But not until I have made a dry run on a backup image and confirmed it works! (I spent several hours today trying to set up boot from a VHD image, so far without success. )
|
|
# ¿ Nov 29, 2015 22:39 |
Well that was certainly a surprise. I need to do nothing to make it boot. I managed to make it boot off a VHD image, and while it took ages (since I put it on a spinny disk) it went without a hitch. However there are some "minor" driver issues, since all USB ports on the new mobo are USB 3 and Windows 7 doesn't have any drivers for that. So no mouse. And no driver for the Ethernet controller either. But I can dump those onto the disk before moving it, so not a blocker by any means.
|
|
# ¿ Nov 30, 2015 21:40 |