|
I guess you weren't able to remove the 4x20 LCD off the driver board to make it fit? (with driver board laying down behind) Either way, the smaller LCD looks good!
|
# ¿ Sep 16, 2020 14:43 |
|
|
# ¿ May 13, 2024 08:45 |
|
cursedshitbox posted:the lcd directly interfaces with the large board that it is clamped to. There's two potted chips on the back. If it weren't for the potted chips I'd spin up a board that would fit. I really wanted to keep the 20x4 panel at minimum. I was meaning to desolder the lcd component from the driver board with the potted chips and make a ribbon cable between them, allowing the pcba to fit laying down. Not sure how that particular LCD is attached, some use this poo poo flex contact instead of soldered pads.
|
# ¿ Sep 25, 2020 04:53 |