3D Printers: You can anneal some posts in a sous vide cooker

Register a SA Forums Account here!
JOINING THE SA FORUMS WILL REMOVE THIS BIG AD, THE ANNOYING UNDERLINED ADS, AND STUPID INTERSTITIAL ADS!!!

You can: log in, read the tech support FAQ, or request your lost password. This dumb message (and those ads) will appear on every screen until you register! Get rid of this crap by registering your own SA Forums Account and joining roughly 150,000 Goons, for the one-time price of $9.95! We charge money because it costs us money per month for bills, and since we don't believe in showing ads to our users, we try to make the money back through forum registrations.

The Something Awful Forums > Discussion > Hobbies, Crafts, & Houses > 3D Printers: You can anneal some posts in a sous vide cooker

Wangsucker 69: Feb 7, 2004; Shut up, you old bat.

Hello! My prints have been failing alot recently, and I'm hoping its not time to get a new printer. My Mono X is three years old. I have a vat band and the resin was right around 32 degrees Celsius. I'm going to post my settings and the most recent failure to see if anyone here has any ideas. TIA

Wangsucker 69 fucked around with this message at 23:54 on Apr 10, 2024

# ¿ Apr 10, 2024 23:43

Adbot: ADBOT LOVES YOU

# ¿ May 17, 2024 15:55

Wangsucker 69: Feb 7, 2004; Shut up, you old bat.

deimos posted:

How is you FEP film looking? Also how old is your resin?

Resin is a couple months old, the FEP is new, I�m wondering if I have it too tight or loose?

When I changed it I used a Gatorade cap under the FEP, I read somewhere that would help from over tightening.

# ¿ Apr 11, 2024 01:30

Wangsucker 69: Feb 7, 2004; Shut up, you old bat.

All I needed was to level the drat build plate. Le sigh. Thanks for the suggestions folks!

# ¿ Apr 12, 2024 04:32

The Something Awful Forums > Discussion > Hobbies, Crafts, & Houses > 3D Printers: You can anneal some posts in a sous vide cooker