|
DICK DICER posted:3/4 corners completed. Shot an e clip and flanged nut/washer down into a column never to be seen again. Did you loudly exclaim, "Jesus!"?
|
#
?
Sep 28, 2017 20:45
|
|
|
|
| # ? May 10, 2024 20:11 |
|
|
Of the words allegedly exclaimed, 'Jesus' did not happen to make the list
|
|
#
?
Sep 28, 2017 20:53
|
|
|
how long of a telescoping magnet-on-a-stick would you need, to fish them out?
|
|
#
?
Sep 28, 2017 21:20
|
|
|
I think we should cut a hole from underneath.
|
|
#
?
Sep 28, 2017 21:22
|
|
|
Invert the entire trailer or use a powerful shop vac, if the post is reasonably sealed along its length
|
|
#
?
Sep 28, 2017 21:24
|
|
|
Dagen H posted:Did you loudly exclaim, "Jesus!"?  I recently learned that "Jesus clip" is a regional term for an e-clip / circlip so it's nice to feel in on the joke.
|
|
#
?
Sep 28, 2017 21:28
|
|
|
Dagen H posted:Did you loudly exclaim, "Jesus!"? Pretend I can figure out the way to make it play from 0:42 https://youtu.be/541-B8omEXA
|
|
#
?
Sep 28, 2017 21:33
|
|
|
https://www.youtube.com/watch?v=541-B8omEXA&t=42scode:
|
|
#
?
Sep 28, 2017 21:34
|
|
|
HandlingByJebus posted:
It's a military term for the nut that holds the rotor on to a helicopter as well.
|
|
#
?
Sep 28, 2017 21:37
|
|
|
MikeyTsi posted:It's a military term for the nut that holds the rotor on to a helicopter as well. gently caress. There's one nut? Just... just one. A single nut. Jesus.
|
|
#
?
Sep 28, 2017 21:59
|
|
|
Leperflesh posted:gently caress. There's one nut? Just... just one. A single nut. I mean, yeah, kindof has to be. 
|
|
#
?
Sep 28, 2017 22:10
|
|
|
I mean you could weld something, or maybe have two nuts locked to each other and then welded, or they could even run the shaft through the props and then mechanically upset it so it's wider so the props physically can't come off, or any number of other ways of doing things. That is a substantial looking nut but still. Obviously I'm no helicopter engineer and I'm sure they know what they're doing but I find it a surprising decision.
|
|
#
?
Sep 28, 2017 22:16
|
|
|
DICK DICER posted:Pretend I can figure out the way to make it play from 0:42 Better still: https://www.youtube.com/watch?v=Or-40E0dl2M&t=12s
|
|
#
?
Sep 28, 2017 22:17
|
|
|
MikeyTsi posted:It's a military term for the nut that holds the rotor on to a helicopter as well. So called because if the engine fails, you can do a reasonable sort of glide down to a non-spine shattering landing, but if the wings fall off, well, you're going to be meeting Jesus very soon.
|
|
#
?
Sep 28, 2017 22:20
|
|
Bad Angus! Bad!
|
Leperflesh posted:I mean you could weld something, or maybe have two nuts locked to each other and then welded, or they could even run the shaft through the props and then mechanically upset it so it's wider so the props physically can't come off, or any number of other ways of doing things.
|
|
#
?
Sep 28, 2017 22:29
|
|
|
Mr. Nice! posted:I mean, yeah, kindof has to be. Leperflesh posted:I mean you could weld something, or maybe have two nuts locked to each other and then welded, or they could even run the shaft through the props and then mechanically upset it so it's wider so the props physically can't come off, or any number of other ways of doing things. The dark bit on the lower left of the second photo is a locking retainer that engages the teeth on the outer edge of the nut, and is pinned in to keep the Jesus nut from backing off. Newer designs have a lot less of a single failure point locking the rotors on, as such: http://turn-the-page.co.uk/wp-content/uploads/2017/09/Jesus-nut-767x574.jpg?x52365 edit: gently caress, non https image. Edited to a URL.
|
|
#
?
Sep 28, 2017 22:33
|
|
|
But if some rear end in a top hat gets off a lucky shot with an RPG that hits the shaft below the swashplate, you're turbofucked.
|
|
#
?
Sep 28, 2017 22:59
|
|
|
I absolutely love how all calm and statement-of-fact Pinhead is 
|
|
#
?
Sep 28, 2017 23:20
|
|
|
They were talking about Valentine on NPR when i Was driving a bit ago.Something about a big fancy brewery opening
|
|
#
?
Sep 28, 2017 23:35
|
|
|
Dude is Runza just jack in the box
|
|
#
?
Sep 28, 2017 23:37
|
|
|
DICK DICER posted:Dude is Runza just jack in the box *Eagerly awaits Dick's post Runza-eating report* Runza's a local chain that makes this beef-and-cabbage-stuffed roll of same name (this being the swiss mushroom variety)
|
|
#
?
Sep 28, 2017 23:43
|
|
|
The spicy jack runza is the poo poo. The Italian runza is best but they only have it every few years. I had a runza burger for lunch today actually. Don't forget to order frings.
|
|
#
?
Sep 28, 2017 23:47
|
|
|
DICK DICER posted:I absolutely love how all calm and statement-of-fact Pinhead is I don't even really like the Hellraiser movies, but that line is perfect. "Not quite."
|
|
#
?
Sep 28, 2017 23:56
|
|
|
In 25 minutes, 7:15 my time I will be going live again in hopes of finally finnishing the trailer roof project for anyone wanting to tune in to the FB group
|
|
#
?
Sep 29, 2017 00:52
|
|
|
Applesnots posted:They were talking about Valentine on NPR when i Was driving a bit ago.Something about a big fancy brewery opening This is a neat! Amazing that Valentine makes an NPR story. http://www.npr.org/2017/09/28/554331255/build-a-brewery-and-they-will-come edit: They're hiring! 14 should go over there and apply. Panaflex fucked around with this message at 00:57 on Sep 29, 2017 |
|
#
?
Sep 29, 2017 00:53
|
|
|
Panaflex posted:This is a neat! Amazing that Valentine makes an NPR story. It's pretty neat how craft breweries can pump up the local economy in small lovely places. It's been cool getting to see how the network of local suppliers and businesses they pull together employ/engage the locals/yokels. Valentine is lucky. It's also been pretty neat watching anti-liquor southern politicians lose their poo poo over them.
|
|
#
?
Sep 29, 2017 01:03
|
|
|
10 minute warning for AInsatzgrüppen
|
|
#
?
Sep 29, 2017 01:06
|
|
|
That was fun. I'm glad we had fun.
|
|
#
?
Sep 29, 2017 02:18
|
|
|
The stream ended. Last I saw you were gonna lube your shaft and see if you could get it up easier?
|
|
#
?
Sep 29, 2017 02:24
|
|
|
Yep the silicone spray helped a good measure but I'll need some nice thick sticky grease holy poo poo which I have out in the loving trukk
|
|
#
?
Sep 29, 2017 02:30
|
|
|
DICK DICER posted:finnishing the trailer roof project Perävaunun kattoprojekti?
|
|
#
?
Sep 29, 2017 02:32
|
|
|
please share pictures of the completed campsite
|
|
#
?
Sep 29, 2017 02:34
|
|
|
Sormus posted:Perävaunun kattoprojekti? I don't care if I have the country right I just want an excuse to post Korpikaampi
|
|
#
?
Sep 29, 2017 02:55
|
|
|
THE ROOF THE ROOF THE ROOF IS
|
|
#
?
Sep 29, 2017 02:57
|
|
|
Guess who's got an almost working screen door 
|
|
#
?
Sep 29, 2017 03:16
|
|
|
The Polish Navy?
|
|
#
?
Sep 29, 2017 03:25
|
|
|
Sure would be nice if the only rotted wood in the joint didn't happen to be the door frame lock in rails Real nice
|
|
#
?
Sep 29, 2017 03:27
|
|
|
Mom's gonna fix it all soon Mom's comin round to put it back the way it aughta be
|
|
#
?
Sep 29, 2017 04:01
|
|
|
learn to swim
|
|
#
?
Sep 29, 2017 04:08
|
|
|
|
| # ? May 10, 2024 20:11 |
|
|
DICK DICER posted:THE ROOF 
|
|
#
?
Sep 29, 2017 04:23
|
|
